
Digital BUS-WATCH
®
PC Software Manual
Radio Engineering Industries, Inc.
640372 - Rev D - 12/15/2010
Page 72 of 99
Restart Device
The Restart device function is used to restart a network connected DVR.
Remote restart dialog box
Selecting the restart function from the list of operations will display a confirmation dialog box.
Click OK to initiate a reboot on the selected DVR, or Cancel to skip the operation and return to
the Remote Control dialog box. Upon confirmation of remote restart, the selected DVR will
begin the restart process. Recording on the DVR will stop, and the DVR will restart after a short
interval (approximately 1 minute).
The remote restart function is useful for restarting a DVR for which recording has been stopped
using the remote shutdown function, or for use by an administrator for restarting the DVR to
initiate re-reading of certain files on the DVR hard drive, after updating.
Configure Device
The configure device function launches the embedded Remote Setup application to set the
configuration parameters of a network connected DVR.
Selecting the remote configuration option from the list of operations will launch the Remote
Setup application. The application will connect to the selected DVR and retrieve and display the
current configuration parameters of the DVR.
The DVR configuration settings match the configuration settings of the DVR firmware. The
settings shown by the Remote Setup application are organized to match the organization of the
Setup menus of the R1001/R4001/R8001 Mobile DVR firmware. Please consult the
R1001/R4001/R8001 Mobile DVR manual for information on setting the DVR configuration
settings.
Comentarios a estos manuales